Energy Watchdog

Find that appliance that's costing you too much with no fancy equipment!

The world is going green, and electricity costs are rising. How would you like a tool that will enable you to check the efficiency of your electrical appliances, and find those that are costing you more than they should. No fancy equipment is required, just your phone and this app.

How does it work:

- When electricity flows, it generate a magnetic field. The app detects the change in these magnetic fields through the magnetometer/compass in your smartphone. At the moment, we only detect if electricity is flowing or not.

- Place your phone in close proximity to the motor of a fridge or at a point of maximum magnetic field dispersion e.g. on the plug or alternatively on the cable. Try different orientation ie vertical horizontal. A narrow bar on the right of the display shows the instantaneous value of the magnetic field to assist with optimum placement.

NOTE: Do not place your phone on un-insulated conductors, you will get shocked and may damage your phone!

- There are two measurement modes

1. Free running

2. Timer based - useful for doing overnight tests of standby consumption.

- The power consumption of the appliance needs to be configured - default is 1 kW

(Or use the new experimental analogue algorithm to determine how much your appliance is using)

- The currency and costs per kilowatt can be configured - currency is auto-detected and the rate is defaulted at $ 0.12/kWH

- Due to different board layouts in smartphones and the use of different magnetometers it may be required to adjust the detection settings. There are 2 algorithms available:

1. Historical (Default)

Default values: Magnetic sensitivity of 0.8, sample depth of 50, and number of matching samples 20%.

2. Past Average

Default values: Magnetic sensitivity of 5.0, average period of 10 seconds

Please provide us with feedback on what works for you and your smartphone. ([email protected])

Use Cases:

- Providing information around discretionary and base costs associated with HVAC appliances (Fridge , deep freeze, heater, hot water cylinder (geyser)) by monitor use and standby consumption.

- Support business cases of switching to more efficient and or smaller appliances for example comparing consumption with quarterly costs of highest efficiency fridges on the market

- Finding defect of partially defect appliances i.e. permanently on deep freeze not reaching its target temperature

- Determining what the cost difference is between taking a shower versus a bath

In effect, you can use your smartphone as a non-intrusive smart meter.

Please provide us with feedback.

The default settings were tested on an HTC Desire.

NOTE: The primary intent of providing the magnetometer on the smart phones is for compass functionality. Compass functionality may have opposing goals to the goals of the Energy Watchdog. The compass would aim at suppressing of 50Hz mains interference while Energy Watchdog relies on detecting of 50 Hz signals. The suppression of 50Hz interference may under certain circumstances e.g. temperature variantions reduce the sensitivity of the Energy Watchdog for detecting mains induced magnetic field changes . in best case scenarios i.e. when measuring on extension plugs that disperse the magnetic field sensitivity of 90 and better has been achieved.

What's New in the Latest Version 2.1.0

v2.0.0
- Should work better on various resolution screens
- Added an 'Alerts' feature, tap the triangle on the bottom right (Needs notifications add-on)
- Added an experimental analogue measurement algorithm, it tries to detect how much power is being used